Shoe Goo Shoe Repair Clear
On This Page
Read directions and test small area before use. 1. Surface should be clean, dry and free of dirt. 2. Puncture seal in neck of tube using pointer cap. Product can be used between 50 and 90 degrees F/10 and 32 degrees C. 3. Apply directly to each surface to be protected, bonded or repaired. Allow to partially cure, approximately 2 minutes before mating surfaces. For waterproofing and protecting use thin coats to build a thick coating, allowing each layer to set 3-4 hours. 4. Allow repair to dry for 24 hours. Depending on materials and temperature, maximum strength may not be reached for 48 to 72 hours. 5. For future easy cap removal, apply a thin coat of petroleum jelly to the threads of the tube before replacing the cap. 6. Clean uncured adhesive with acetone or citrus-based solvents. Cured material may be removed by cutting or scraping. 7. Repairing and protecting skateshoes: shoegooskate.com. Note: May damage finished surfaces. Avoid such contact until completely dry. Not recommended for use on polystyrene, polyethylene, polypropylene, Styrofoam™ or paper products. Not recommended for any items that come into contact with food, drinking water or animals.
DescriptionShoe Goo® Original Clear Shoe Repair. Rebuild, protect, repair. Permanent fast repair. Waterproof. For use on: Leather. Rubber. Vinyl. Canvas.
Other DescriptionA superior adhesive/sealant that permanently protects/repairs all types of footwear. For technical assistance, call (800) 767-4667. www.eclecticproducts.com. www.shoegoo.com.
WarningsFlammable, vapor harmful.
Contains toluene and petroleum distillate. May cause dizziness, headache or nausea. Causes eye, skin, nose and throat irritation. Intentional misuse by deliberately concentrating and inhaling contents may be harmful.
This product contains a chemical known to the state of California to cause birth defects or other reproductive harm. Keep away from heat, spark and flame. Extinguish all sources of ignition during use and until all vapors are gone. Prevent build-up of vapors by opening all windows and doors to achieve cross ventilation. Use only with adequate ventilation. To avoid breathing vapors, open windows and doors or use other means to ensure fresh air entry during application and drying. Close container after use. Avoid contact with eyes and skin. Wash thoroughly after handling.
First aid: If you experience difficulty in breathing, leave the area to obtain fresh air, If continued difficulty is experienced, get medical assistance immediately. In case of eye contact, flush immediately with plenty of water and get medical attention; for skin, wash thoroughly with soap and water. If swallowed, do not induce vomiting; get medical attention.
Keep out of reach of children.