Command Damage-Free Hanging Poster Strips - 12 CT



To apply: 1. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. Separate strips. 2. Remove green liners. Position strips on back of poster as shown. Press firmly. 3. Remove black liners. Position poster on wall. Important: press each strip firmly for 30 seconds. To remove: 1. Lift corner of poster to reveal tabs. 2. Never pull strip towards you. 3. Lightly press top of strip and grab tab, stretch slowly straight down along wall. 4. Continue stretching at least 6 inches (15 cm) until strip releases from wall. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could lose adhesion above 105 degrees F (40 degrees C).



Command™ Damage-Free Hanging Poster Strips. Posters. Holds strongly. Removes cleanly. 12 small strips. 3M.

Other Description

For questions, ideas and special offers go to Not intended for picture hanging. Instead use Command™ picture hanging strips, sawtooth or wire-backed hangers. 3M and Command are trademarks of 3M. Made in U.S.A. with U.S. and globally sourced materials. The following statements only apply to products distributed in the USA. Limited warranty: This 3M product will be free from defects in material and manufacture. If this product is defective, your exclusive remedy shall be, at 3M's option, replacement of the product or refund of the purchase price. Limitation of liability: 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. All rights reserved. 1-800-934-7355. ©2013, 3M.


Caution: do not use with wallpaper. May not adhere well to vinyl surfaces. Do not use for antiques, heirlooms, or other valuable or irreplaceable items. Do not hang items over beds.


3M, Construction and Home Improvement Markets Division
3M Center St. Paul, MN 55144-1000