Flex Seal Rubber Sealant Coating Spray, Clear
14 oz (396 grams)
On This Page
Directions
So easy to use! Read entire can. Wear face and eye protection, protective gloves and clothing. Surface must be clean, dry and free of grease, oil and dirt. Shake Well: Spray 8 inches to 12 inches from surface using a sweeping motion. Apply several coats until all cracks and holes have been completely filled. Each coat must be dry before applying additional coats. Depending on temperature and humidity, allow up to 24 hours between coats and 48 hours to fully cure. After each use, invert can and apply a short burst to clear nozzle. Hint: Make sure all cracks and holes have been completely filled and is fully cured before testing. If light passes through apply additional coats. Use only in a well ventilated area. Prevent vapor buildup by opening doors and windows Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. Do not smoke. When covering large areas indoors, eliminate ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. When applying to large areas indoors, do not exceed use of 1/2 of a can before allowing one hour for the coating to dry and vapors to dissipate before using again. Works best at can. Note: This product has not been tested for use in portable water systems. may not be compatible with some plastics, vinyls and rubbers. Not intended for use by Professional Roofers. Carb Coating Category: Flexible coating max 1.6 MIR. To Open: Insert screwdriver in slot. Pry off by pulling up on handle.
Product Details
As seen on TV. Stops leaks. Seals & protects. Covers easily. Excellent for: roof leaks; gutters; skylights; windowsills; flashings; duct work; foundations; awnings; chimneys; downspouts; vent pipes; A/C drip pans; RV's; campers; trailers; projects and so much more! Coat, seal & protect. Stop leaks fast! Flex Seal is an easy to use rubberized coating that sprays out as a thick liquid, seeps into cracks and holes and dries to a watertight, flexible, rubberized coating. Flex Seal seals out air, water and moisture and helps prevent rust and corrosion. Once dry, Flex Seal can be painted. Flex Seal is the easy way to coat, seal, protect and stop leaks fast! www.flexsealproducts.com. 24 Hour Medical Emergency: 1-866-836-8855. To Reorder Please Visit: www.flexsealproducts.com. Please recycle when empty. Made in the USA from domestic and foreign materials.Nutrition Facts
Warnings
Warning: This product may expose you to chemicals, including Ethyl benzene, known to the State of California to cause cancer, and Toluene, known to the State of California to cause birth defects and other reproductive harm. For more information go to www.P65Warnings.ca.gov.,First Aid: If Eye Contact: Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. Remove contact lenses, if present and easy to do. If irritation persists get medical attention immediately. If Skin Contact: Wash with soap and water. If irritation persist seek medical attention. Inhalation: Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial vomiting. Call physician immediately.,Danger: Extremely flammable. Harmful or fatal if swallowed. Vapor harmful. May cause eye, skin, and respiratory tract irritation. Contents under pressure. See other cautions on back panel. Keep out of the reach of children. Danger: Contains (CAS No): Toluene (108-88-3), acetone (67-4-1), parachlroobenzoltrifluoride (98-56-6), solvent naphtha (petroleum), light aromatic (64742-89-8) and liquefied petroleum gas (68476-86-8). Use only in a well ventilated area. Prevent vapor buildup by opening doors and windows. Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. Do not smoke. When covering large areas indoors eliminate ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. Intentional misuse by concentrating and inhaling the product can be harmful or fatal. Avoid contact with eyes or prolonged contact with skin. Do not puncture or incinerate container. Do not expose to heat or store at temperatures above 120 degrees F.Manufacturer
SWIFT RESPONSE
Weston, FL 33331
UPC
00855647003514