Flex Shot Thick Rubber Adhesive Sealant, White
8 oz (226 g)
On This Page
Directions
Directions for Use: (1) All surfaces must be clean, dry and free from dirt, grease and oil. (2) Hold can at 45 degree angle, push against the nozzle side and apply into the joint of seam to obtain full contact between surfaces. (3) Flex Shot can be smoothed within 5 minutes of application. Remove express immediately with a dry paper towel. (4) sealant form a tack free skin in 20 minutes. Length of dry time depends upon temperature and humidity usually cure within 24 to 48 hours. (5) After using, extend a small amount of material beyond the end of the nozzle. This will cure and form a seal for the remaining material. Pull out this curd plug when you are ready to use again.
Product Details
The easy way to caulk, bond & seal. As seen on TV. Mildew resistant. Easy to use! Leak proof seal! Strong bond! Excellent for: Kitchens & baths sinks & showers tubs & tiles windows & skylights roofs & gutters autos & boats RV’s & campers PVC pipes duct work. No caulking gun needed! Flex shot is a thick, rubberized paste that fills cracks and holes. If dries to a tough, flexible, watertight seal. Flax Shot seals out water, air and moisture. Flex Shot comes with an easy to use nozzle that gives you a perfect bead every time. No need for a caulking gum! Flex Shot is the easy way to caulk, bond & seal virtually everything. www.flexshot.com. Costumer service: 877-370-0632, to order more flex shot: 877-857-5792. www.flexshot.com. Contains no CFCs which no cfcs deplete the ozone layer. Made in USA.Nutrition Facts
Ingredients
Contains: Dimethylsiloxane (Cas 70131-67-8), Silica (Cas 7631-86-9), Methyltriacetoxysilane (Cas 4253-34-3), Ethyltriacetoxysilane (Cas 17689-77-9), Petroleum Distillates Cas 64742-46-7), Diflouroethane (Cas 75-37-6).Warnings
Warning: Causes skin irritation. Contents under pressure. Contains flammable propellant read rear panel for other cations! Keep out of reach of children. Warning: Uncured sealant causes irritation on contact with skin and eyes. In case of contact with skin, wipe off with paper towels of cloth and wash with soap and water. In case of eye contact, immediately flush with water for 15 minutes. Call a physician immediately. Use with adequate ventilation. Contents under pressure. Do not puncture or incinerate. Do not remove rubber plug. Do not store at temperatures above 120 degree F. Do not store in automobiles, in direct sunlight or any area with temperatures above 120 degree F. Keep container away from heat, sparks and flame. See safety data sheet.Manufacturer
Swift Response
Weston, FL 33331
UPC
00855647003385