Flex Seal Brite Sealant
14 oz (396 g)
On This Page
Directions
Directions: So easy to use! Protective clothing recommended. Use only in a well ventilated area. When using Inside, prevent vapor buildup by opening doors and windows. Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. When covering large areas indoors, eliminate Ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. When applying to large areas indoors, do not exceed use of 1/2 of a can before allowing one hour for the coating to dry and vapors to dissipate before using again. Shake well and spray using an even sweeping motion. Apply several even coats until all cracks and holes have been filled. Allow Flex Seal to dry completely before applying the next coat. Fully cures in 24 hours. Spray a larger area than where the leak occurred and feather edges. Works best at can temperatures above 60 degrees F. Occasionally shake can throughout application. To Open: Insert screwdriver in slot. Pry off by pulling up on handle.
Product Details
As seen on TV. Liquid rubber in a can! Stop leaks. Seals & protects. Covers easily. Excellent for: skylights, gutters, downspouts, flashings, windowsills, pvc pipes, roof leaks, hoses, chimneys, duct work, foundations, awnings, vent pipes, a/c drip pans, rv's & campers, trailers and so much more! Stops leaks fast! Jumbo can. Flex Seal is an easy to use rubberized coating that sprays out as a thick liquid, seeps into cracks and holes and dries to watertight, flexible, rubberized coating. Flex Seal seals out water, air and moisture and helps prevent rust and corrosion. Once dry, Flex Seal can be painted. Flex Seal is the easy way to coat, seal, protect and stop leaks fast! www.flexsealproducts.com. Steel. No CFCs. Contains no CFCs which deplete the ozone layer.Nutrition Facts
Warnings
Warning: This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.,First Aid: If Eye Contact: Flush with large amount of cool running water for at least 15 minutes while holding upper and lower lids open. Remove contact lenses, if present and easy to do. If irritation persists get medical attention immediately. If Skin Contact: Wash with soap and water. If irritation persists seek medical attention. Inhalation: Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration. If Ingested: Do not induce vomiting. Seek medical attention immediately.,Danger: Extremely flammable. Harmful or fatal if swallowed. Vapor harmful. May cause eye, skin, and respiratory tract irritation. Contents under pressure. See other cautions on back panel. Keep out of the reach of children. Danger: Contains Toluene (108-88-3), Odorless Mineral Spirits (64742-48-9), Aliphatic Petroleum solvent (64742-89-8), Titanium Dioxide (13463-67-7) and Liquefied Petroleum gas (68476-86-8). Use only in a well ventilated area. When using inside, prevent vapor buildup by opening doors and windows. Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. When covering large areas indoors eliminate ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. intentional misuse by concentrating and inhaling the product can be harmful or fatal. Avoid contact with eyes or prolonged contact with skin. Do not puncture or incinerate container. Do not expose to heat or store at temperatures above 120 degrees F. Note: After each use, invert can and apply a short burst to clear nozzle. Not intended for use by Professional Roofers. This product has not been tested for use in potable water systems.Manufacturer
Swift Response
Weston, FL 33331
UPC
00855647003118